Replay XD720 Spécifications télécharger pdf (Page 5)

1. Find the best mounting location for your Replay XD720 and check your angles.

Rigid surfaces are ideal for the best video quality. Note: You can make a test recording and check

it on an iPad/Mac/PC.

2. Snap Replay XD720 into u-shape camera holder and rotate 360º to desired rotation.

3. Attach VHB SnapTray adhesive mount to a clean smooth surface.

-Flat SnapTray’s are good for at smooth surfaces.

-Curved SnapTray’s are good for curved surfaces such as Helmets & Radius surfaces.

The 3M VHB adhesive is not recommended for textured surfaces.

4. Slide HeimLock mount into SnapTray until it is fully seated and clicks.

5. Adjust swivel 360º or tilt ~8º by releasing the heim cam lever and position Replay

XD720 in desired direction, then lock the cam lever. Make sure the cam lever is tight.

There is an adjustable tension wheel and phillips screw (

) to make sure you always have

a positive tight lock. You can tighten the screw clockwise in 1/4 turn increments to nd

the desired tension when the cam lever is locked.

HEIMLOCK MOUNT

See our full range of mounts at www.Replayxd.com

VHB SnapTray HeimLock Mount

Unlock

Lock

Tighten

Set screw

TiltSwivel

IMPORTANT

Use rubbing alcohol to clean

the mounting surface. Wipe

dry the surface. Apply your

VHB mount to surface. Press

and hold for sixty seconds to

allow adhesive to bond to

the surface. Bond strength

will increase through time.

At room temperature,

wait for at least 24 hours

to achieve 90% bonding

strength, and 72 hours for

100% bonding strength.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Replay XD720 Spécifications Page 5